The main pipeline must have an inclination of 1 ° ~ 2 ° for the drainage of condensate in the pipeline. The pressure drop of the pipeline must not exceed 5% of the pressure of the air compressor, so it is better to use a larger pipe diameter when piping. The branch pipeline must be
The vibration generated by the screw compressor is small, so there is no need to make a fixed foundation. But the ground must be flat and hard. The bottom of the compressor should be covered with 5-10mm soft pads or anti-vibration pads to prevent vibration and noise.
For the Air-cooled type air compressor system, we recommended to install air ducts to direct the cooling hot air out: For the Water-cooled type air compressor system, need the water cooling system. The cooling water pressure should be 2~6bar Valves should be installed at the inlet and outlet if the cooling water should be clean,
The humidity of the air should be low, with little dust, clean air. If the factory environment is poor and dusty, you must install pre-filter equipment.
The ambient temperature should be 2~40℃. The higher the ambient temperature, the less the output air volume of the compressor If below 2℃, the air compressor must adopt measures to avoid freezing.
The distance between the compressor and the wall must be at least one meter; The distance between the air compressor and the top space is at least one meter; The main channel distance of the compressor room is at least 1.5 meters.
In order to avoid maintenance difficulties, poor compressed air quality, loud noise, bad ventilation condition and so on. It is important to pay attention to the following requirements before installing.